Table of Contents
Advertisement
Chapter 3 Setup
1.
Turning on the Server
Pressing POWER Switch at the front of the server turns on the server.
Turn on the server by using the following procedure.
Turn on a display, an Uninterruptible Power Supply (UPS), and other peripherals.
Remove Front Bezel.
When the STATUS lamp flashes green (once per second), wait until the lamp lights in steady state.
Press POWER Switch at the front of the server.
POWER LED flashes green (once per second) and after a while, logo appears on the display.
・2.5-inch drive model
186
If the power cord is connected with the power supply control unit such as
Note
uninterruptible power supply (UPS), make sure that the power supply
control unit is turned ON.
Important
Do not connect/disconnect USB devices during POST execution.
POWER Switch
Express5800/R120h-1M User's Guide
1. Turning on the Server
Advertisement
Table of Contents
