Table of Contents
Advertisement
Chapter 2 Preparations
・Full height
Lift up the full-height bracket in Slot 3 of riser card. Take off the two screws and remove the blank cover.
4.
Insert PCI board into the riser connector, lower the bracket and return and fix the latch.
106
Note
Keep each removed blank covers.
Important
Do not touch the terminal part of riser card or PCI card and the signal pins
of electric parts installed on the board. Installing boards with dirt or oil can
cause malfunction.
Note
Make sure that the edge of a PCI card bracket is seated into the fixed slot of
the riser card.
Depending on type of PCI cards, the terminal part of the PCI card may be too
large to fit in the connector.
If you have trouble installing the card, remove the card once and try again. If
you apply excessive pressure on the card, a PCI card or riser card might
break.
Express5800/R120h-1M User's Guide
1. Installing Internal Optional Devices
Advertisement
Table of Contents
