Table of Contents
Advertisement
Replacing the Fuel Filter
Service Interval: Every 200 hours
1.
Park the machine on a level surface, engage
the parking brake (if applicable), and lower the
grinder.
2.
Shut off the engine and remove the key.
Figure 37
Electrical System
Maintenance
Electrical System Safety
•
Disconnect the battery before repairing the
machine. Disconnect the negative terminal first
and the positive last. Connect the positive terminal
first and the negative last.
•
Charge the battery in an open, well-ventilated
area, away from sparks and flames. Unplug the
charger before connecting or disconnecting the
battery. Wear protective clothing and use insulated
g242257
tools.
•
Battery acid is poisonous and can cause burns.
Avoid contact with skin, eyes, and clothing. Protect
your face, eyes, and clothing when working with a
battery.
•
Battery gases can explode. Keep cigarettes,
sparks, and flames away from the battery.
Servicing the Battery
Service Interval: Every 25 hours—Check the battery
Always keep the battery clean and fully charged. Use
a paper towel to clean the battery case. If the battery
terminals are corroded, clean them with a solution of
4 parts water and 1 part baking soda. Apply a light
coating of grease to the battery terminals to reduce
corrosion.
Voltage: 12 V with 350 A (cold cranking) at -18°C
(0ºF).
WARNING
Battery terminals or metal tools could short
against metal machine components, causing
g033082
sparks. Sparks can cause the battery gasses
to explode, resulting in personal injury.
• When removing or installing the battery,
do not allow the battery terminals to touch
any metal parts of the machine.
• Do not allow metal tools to short between
the battery terminals and metal parts of the
machine.
28
electrolyte level.
Advertisement
Table of Contents
