Table of Contents
Advertisement
Using the Entry List
When any source adjustments are made, the adjustments are automatically registered in the Entry
List. The (adjustment values of ) registered signals can be loaded from the Entry List whenever
necessary.
However, only up to 100 patterns can be registered in the Entry List. When 100 patterns have been
registered in the Entry List, an error message is then displayed and no additional patterns can be
registered. You should thus delete (adjustment values of ) signals that are no longer needed.
If the [ENTRY LIST] window is not displayed, switch the menu to [ADVANCED].
To switch the menu between [ADVANCED] and [BASIC], select [SETUP] → [CONTROL] → [TOOLS]
→ [ADMINISTRATOR MODE] → [MENU MODE]. (→ page 132)
Entering the currently projected signal into the Entry List [
1. Press the ▲ or ▼ button to select any number.
2. Press the ◀ or ▶ button to select [
(STORE)] and press the ENTER button.
88
5. Using On-Screen Menu
(STORE)]
Advertisement
Table of Contents
Troubleshooting
