Device Designs - ABB EBN861 Operating Instruction

EBN853 / EBN861 ELECTRONIC UNIT | OI/EBN853/EBN861/EX-EN REV. C

Device designs

EBN853
IP rating
Humidity
Ambient temperature
Transport and storage temperature
Long-term storage temperature
Mounting position
Vibration stress
Paint
Electrical connection
Weight
EBN861
IP rating
Humidity
Ambient temperature
Transport and storage temperature
Long-term storage temperature
Mounting position
Vibration stress
Paint
Electrical connection
Weight
Change from one to two columns
IP 66 in accordance with IEC 60529 / EN 60529
NEMA 4X in accordance with CAN / CSA22.2 No. 94
≤ 95% annual average; condensation not permitted
−25 to 55 °C (−13 to 131 °F)
−25 to 70 °C (−13 to 158 °F)
−25 to 40 °C (−13 to 104 °F)
On vertical mounting plate, lateral cable gland, left
Maximum 150 Hz: acceleration: 1 g (in accordance with EN 60068-2-6, Table C.2)
2-layer component epoxy (RAL 9005, black)
Mains supply via screw terminals; all other connections made via screw-type plug connectors
Connection cable between electronic unit and actuator tightly fastened to the electronic unit, from the
actuator side using a connector to the connection to the actuator. Maximum cable length 100 m (328 ft).
In actuators in explosion-proof design, the connection cable is tightly fastened to the actuator without a
connector through the screw terminals.
Optional, loose cable set supplied acc. to length requirements
11 kg (24 lbs)
IP 66
≤ 95% annual average; condensation not permitted
-25 to 55 °C (-13 to 131 °F)
-25 to 70 °C (-13 to 158 °F)
-25 to 40 °C (-13 to 104 °F)
On vertical mounting plate, cable gland at the bottom
Maximum 150 Hz: acceleration: 1 g (in accordance with EN 60068-2-6, Table C.2)
2-layer component epoxy (RAL 9005, black)
Mains supply via screw terminals; all other connections made via screw-type plug connectors
Connection cable between electronic unit and actuator tightly fastened to the electronic unit, from the
actuator side using a connector to the connection to the actuator. Maximum cable length 100 m (328 ft).
In actuators in explosion-proof design, the connection cable is tightly fastened to the actuator without a
connector through the screw terminals.
Optional, loose cable set supplied acc. to length requirements
40 kg (88 lbs)
11