Others - Mitsubishi Electric MELIPM Series Instruction Manual

6.1.3 Others

Table 6-4
Parameter
Unit Display
Operation error
Emergency stop
operation
Name
Parameter changing operation was performed
during external operation.
The value that was set is outside the parameter
setting range.
The RES signal remains ON.
The parameter unit is in a connection fault.
• Check the fitting status.
MEMO An operation error does not activate the relay
contact output.
The STOP/RESET key of the parameter unit was
pressed to make a stop during external operation.
MEMO A reset cannot be made in the normal method.
6-5
Get other manuals https://www.bkmanuals.com
6. TROUBLESHOOTING
Possible Cause ( ) and
Corrective Action (•)
Refer to: Pr. 75 [Section 8.2]
6