Check List For Selecting A Device Series - Siemens SIMOCODE pro System Manual

1.4

Check list for selecting a device series

The following check list should help you decide upon the optimum device
series for your requirements:
Standard motor feeders (4 inputs, 3 outputs)
with control functions for direct starters,
reversing starters, intelligent overload relays
Monitoring of stalled rotor, unbalance, phase
failure
Current measuring, current limit monitoring,
overload protection
Earth-fault monitoring via the current
measuring module (internal)
Thermistor motor protection with PTC (binary)
Motor feeder with control function:
Star-delta starters, Dahlanders, pole-changing
starters, soft starters – each also possible in
combination with reversing starter –, solenoid
valves, positioners
Measuring, processing and outputting analog
values e.g. flow rate, fill level, etc.
(if necessary via an analog module)
Current measuring and voltage measurement
Voltage monitoring for undervoltage
Power management, implementing power
considerations (power, cos phi), power
monitoring
More than 4 binary inputs required
(maximum 12)
Table 1-1: Check list for selecting a device series
1) Via current measuring module
2) With expansion modules
3) Via current/voltage measuring modules
SIMOCODE pro
GWA 4NEB 631 6050-22 DS 03
Requirements
System description
SIMOCODE
pro C pro V
(BU1) (BU2)
✓ ✓
✓ ✓
✓ ✓
✓ ✓
✓ ✓
✓
—
✓
—
✓
—
✓
—
✓
—
✓
—
Footnote
1)
1)
1)
1)
1)
2)
3)
3)
3)
2)
1-13