Sending The Device To Customer Service; Removing And Inserting The Cfast Card - Siemens SIMATIC ET 200SP Operating Instructions Manual

Updates
You can install additional updates at a later time. You can find current information on the
operating system at Widows (http://www.windows.com).
Note
In the delivery state, partitions are set up on drive C: and D: on the CFast card with free memory.
See section Partitions in the delivery state (Page 65).
Make sure that sufficient free memory space is available on your CFast card for the installation
of updates.
11.9

Sending the device to customer service

Before sending
Before you send in the CPU 1515SP PC2 for repair:
• Create a backup of your data.
• Back up your SIMATIC license keys on a USB stick.
• Remove your SD/MMC cards.
• Remove your CFast card.
Sending in the device
• Pack the device in its original packaging.
• Enclose identification data (Page 35).
• Send to your Siemens contact partner.
11.10

Removing and inserting the CFast card

Introduction
The CPU 1515SP PC2 has a slot for a CFast card. On this card, you will find the operating system,
your runtime software, the restore area and, after configuration, the project.
Seal the cover for the CFast card to protect the system against unauthorized access.
You must remove the CFast card before you send in the CPU, for example, for repair.
Requirements
• The CPU 1515SP PC2 is disconnected from the power supply.
CPU 1515SP PC2 (F/T/TF)
Operating Instructions, 03/2023, A5E42603425-AC
11.10 Removing and inserting the CFast card
Maintenance
73