Table of Contents
Advertisement
•
Move the utility-traction joystick forward to move the
machine forward
(Figure
•
Move the traction joystick rearward to move the machine
in reverse
(Figure
14).
•
Move the traction joystick to the center (Neutral) position
to stop the machine
(Figure
1. Traction-control cluster
2. Gear-selector switch
Note: The engine speed is controlled with the throttle
buttons on the home screen of the command-center panel;
refer to
Throttle Button (page
Gear-Selector Switch
The gear-selector switch is located on top of the utility-traction
joystick
(Figure
14), and is used to select the transmission gear.
The current gear is displayed on the home screen of the
command center, above and to the left of the tachometer
display.
Attachment-Control Cluster
The attachment-control cluster is located at the operator seat
and is adjacent to the right armrest.
Backfill-Blade / Vibratory-Plow Joystick
The backfill-blade/vibratory-plow joystick operates either
the backfill blade or the vibratory plow, whichever is selected
and displayed on the command center. Move the joystick
controls to change the backfill blade or the vibratory plow
position as follows:
•
Push the joystick forward to lower the backfill blade or
vibratory plow or pull the joystick rearward to raise the
backfill blade or vibratory plow
Note: The function of the joystick depends on the
attachment selected in the command center.
14).
14).
Figure 14
3. Utility-traction joystick
17).
(Figure
15).
•
Move the joystick to the left to tilt the backfill blade to the
left, or move the joystick to the right to tilt the backfill
blade to the right
•
Swing the backfill blade or steer the vibratory plow left or
right as follows:
– Twist the thumb control left to swing the backfill
blade left, or twist the thumb control right to swing
the backfill blade right
– Twist the thumb control left to steer the vibratory
plow left, or twist the thumb control right to steer the
vibratory plow right
Note: The function of the thumb control depends
on the attachment selected in the command center.
•
Pull the trigger on the joystick to float the backfill blade
up and down
(Figure
1. Thumb control
2. Backfill blade / vibratory
plow joystick
3. Rear-wheel steering
switch
Rear-Wheel-Steering Switch
The switch for the rear-wheel steering is used to control the
steering direction (left or right) of the rear wheels. The switch
for the rear-wheel steering is located behind the backfill
blade/vibratory plow joystick.
Vibratory-Plow / Trencher-Motor Joystick
Vibratory Plow
Note: The function of the vibratory plow / trencher motor
joystick depends on the attachment selected in the command
center.
19
(Figure
15).
(Figure
15).
(Figure
15).
15).
Figure 15
4. Vibratory plow / trencher
motor joystick
5. Attachment elevation
switch
6. Backfill-blade-float trigger
Advertisement
Table of Contents
