Toro 25450A Operator's Manual page 47

Figure 65
1. Latch lever
2. Latch button
4. Lift the panel up and then away from the machine
(Figure 66).
Figure 66
1. Latch
3. Side-panel latch
2. Side panel
Installing the Side Panels
1. Align the side panel with the machine frame.
2. Align the mounting bolt at the top of the side panel
with the hole in the support flange of the hood panel
(Figure 67).
1. Hole (support
flange—hood panel)
2. Mounting bolt
3. Apply light inward pressure against the panel at 1 of
the latches.
4. Set the latch by pushing in the latch lever
5. Repeat steps 3 and
6. If the backhoe is installed on the machine, do the
following substeps:
A. Rotate the front end of the walkway to its original
position (Figure
B. Align the hole in the walkway with the hole in the
walkway support bracket
C. Install the retaining pin through the holes.
47
Figure 67
3. Hood panel
4. Side panel
(Figure
4 at the other latch.
64).
(Figure 64).
65).