Lubrication; Greasing The Bearings And Bushings - Toro Groundsmaster 360 Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours
The machine has grease fittings that must be lubricated
regularly with No. 2 general-purpose, lithium-based grease. If
the machine is operated under normal conditions, lubricate
all bearings and bushings after every 50 hours of operation.
Bearings and bushings must be lubricated daily when
operating conditions are extremely dusty and dirty. Dusty
and dirty operating conditions could cause dirt to get into
the bearings and bushings, resulting in accelerated wear.
Lubricate the grease fittings immediately after every washing,
regardless of interval specified.
1. Wipe the grease fittings clean so foreign matter cannot
2. Pump grease into the fittings.
3. Wipe off excess grease.
Figure 30
(Shown with mower deck installed)
33
be forced into the bearing or bushing.