Table of Contents
Advertisement
Samsung Semiconductor, Inc.
The jumpers are located on the I/O Expander board as shown in Figure 18.
ARTIK 530
S
This section discusses some of the configuration options of the ARTIK 530s development platform.
Selecting the Development Kit Power Source
The power source is selected using jumpers JP1 - JP4, located on J702 and J703 of the Platform board. When power
is provided from a DC-5V Adapter OR a Battery, all jumpers are in the 1-2 position. When power is provided from the
DC-5V Adapter and at the same time a battery is connected that is being charged (Battery Charging Mode), all
jumpers are in the 2-3 position.
When the jumpers JP1 - JP4 are in the 1-2 position, either a battery OR the DC-5V adapter can be connected, but
NEVER both at the same time. When the jumpers JP1-JP4 are in the 2-3 position, (Battery Charging Mode) both a
battery and the DC-5V Adapter can be connected at the same time.
Figure 19 shows the default settings and how to switch between the settings. When the ARTIK 530s Development
Board is used with an external power adapter make certain that you use a 5V, 5A adapter with a 2.1 x 5.5mm plug.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
C
ONFIGURATION
Figure 19. Location of Jumpers JP1 - JP4 on the Platform Board
ARTIK 530s Development Kit
22
Advertisement
Table of Contents
