Suzuki NEXA FRONX Owner's Manual & Service Booklet page 197

OPERATING YOUR VEHICLE
Starting off on an uphill/downhill
slope:
Uphill
1) Apply the parking brake firmly so that
the vehicle does not roll backwards.
2) Shift the gearshift lever to the "M" posi-
tion while depressing the brake pedal.
Make sure that the gear position indica-
tor in the instrumental cluster displays
1st gear.
3) Release the brake pedal and depress
the accelerator pedal gradually, and
when the vehicle starts to move,
release the parking brake and depress
the accelerator pedal to start off.
NOTICE
On an uphill slope, never hold the
vehicle at a stop using only the accel-
erator pedal or creeping function. If
you perform this operation for a cer-
tain period of time, a warning buzzer
will sound, and in some cases the
engine will stall. This can also cause
excessive damage to the clutch. In
case the warning buzzer is on, shift-
ing to 2nd gear will not be possible in
manual mode. Always use 1st gear
while starting off on a uphill slope.
Otherwise you may damage the
clutch.
5-33
Downhill
1) Depress the brake pedal and shift the
gearshift lever to the "M" position.
Make sure the gear position indicator to
make sure that the gear is in 1st.
2) Release the brake pedal and depress
the accelerator pedal slowly. Even
though the accelerator pedal is not
depressed, the clutch will be engaged
when the vehicle speed increases.
Backing up
After the vehicle has stopped completely,
depress the brake pedal and shift the gear-
shift lever to the "R" position. Depress the
accelerator pedal slowly as when starting
off in 1st gear. Before backing up, make
sure that reverse gear is selected by
checking the gear position indicator.
76MH0A062
NOTE:
• If reverse gear cannot be engaged even
though the gearshift lever has been
shifted from the "N" to the "R" position,
the system will re-try shifting automati-
cally.This will take some time, noise may
be heard from the gears, and shifting
gear shock may occur. However, they do
not indicate malfunction.
• The "N" indicator will flash, the depress
brake pedal indicator will come on and a
warning buzzer (long pulse sound) will
sound if any of the following cases
occur;
– If you shift the gearshift lever from the
"N" to the "R" position without depress-
ing the brake pedal.
– If the system is unable to re-try shift-
ing.
You should depress the brake pedal and
shift the gearshift lever to "N" position,
then shift to "R" position again a few sec-
onds later.
• The system will not allow shifting to the
"R" position if the vehicle speed is over
about 3 km/h. If the gearshift lever is
operated under this condition, the "N"
indicator in the instrument cluster will
blink. However, when the vehicle speed
drops below about 3 km/h, the gear will
be shifted to reverse. Make sure that the
vehicle has stopped completely before
shifting to the "R" position.
55TH0-74E