Toro 22327 Operator's Manual page 43

5. Using a 1/2 inch drive ratchet, turn the tensioning
screw until the track deflection is 13 mm (1/2
inch) as shown in
Note:
Turning the screw counter-clockwise
tightens the track; turning the screw clockwise
loosens the track.
6. Align the closest notch in the tension screw to
the locking-bolt hole and secure the screw with
the locking bolt and nut
7. Repeat the procedure for the other track.
8. Drive the machine, then park the machine on a
level surface, engage the parking brake, shut off
the engine, and remove the key.
9. Verify that the track deflection is 13 mm (1/2
inch) as shown in
Machines with Wide Tracks
Verify that the tension block is aligned with the green
guide on the decal or that the block is 1.3 cm (1/2 inch)
away from the rear of the tension tube slot
Figure 58
1. Green guide on decal
2. Tension block
1. Park the machine on a level surface, engage the
parking brake, and lower the loader arms.
2. Shut off the engine and remove the key.
3. Remove the locking bolt, spacer, and nut
59).
Figure 56.
(Figure 57).
Figure 56. Adjust if necessary.
(Figure
1. Tension tube
2. Locking bolt
4. Using a 1/2 inch drive ratchet, turn the tensioning
screw until the tension block aligns with the
green guide on the decal or is 1.3 cm (1/2 inch)
away from the rear of the tension tube slot
(Figure
Note:
tightens the track; turning the screw clockwise
58).
loosens the track.
5. Align the closest notch in the tension screw to
the locking-bolt hole and secure the screw with
the locking bolt and nut
6. Repeat the procedure for the other track.
7. Drive the machine, then park the machine on a
level surface, engage the parking brake, shut off
the engine, and remove the key.
8. Verify that the tension block aligns with the
green guide of the decal or is 1.3 cm (1/2 inch)
away from the rear of the tension tube for both
tracks
g203962
(Figure
41
Figure 59
3. Tensioning screw
58).
Turning the screw counter-clockwise
(Figure
(Figure 58). Adjust if necessary.
g029758
59).