Toro 22327 Operator's Manual page 34

4. Engage the parking brake, shut off the engine,
and remove the key.
5. Drain the oil beneath the platform
CAUTION
Components will be hot if the machine
has been running. If you touch hot
components, you may be burned.
Use care to avoid touching hot
components while changing the oil
and/or filter.
Figure 45
6. Remove the oil-fill cap and slowly pour
approximately 80% of the specified amount of oil
in through the valve cover.
7. Check the oil level.
8. Slowly add additional oil to bring the level to the
upper hole on the dipstick.
9. Replace the fill cap.
Changing the Oil Filter
1.
(Figure 45).
2.
3.
4.
5.
6.
g031212
g029385
7.
8.
9.
10.
11.
32
Raise the loader arms and secure with the
cylinder locks; refer to Using the Cylinder Locks
(page 26).
Engage the parking brake, shut off the engine,
and remove the key.
Remove the front cover; refer to
Front Cover (page 28).
Drain the oil from the engine; refer to
the Engine Oil (page 31).
Place a shallow pan or rag under the filter to
catch oil.
Change the oil filter (Figure
Figure 46
Remove the oil-fill cap and slowly pour
approximately 80% of the specified amount of oil
in through the valve cover.
Check the oil level.
Slowly add additional oil to bring the level to the
upper hole on the dipstick.
Replace the fill cap.
Install the front cover; refer to
Front Cover (page 28).
Removing the
Changing
46).
g029749
Removing the