Accessing Internal Components - Toro 22327 Operator's Manual

Removing and Storing the
Cylinder Locks
Important:
Remove the cylinder locks from the
rods and fully secure them in the storage position
before operating the machine.
1. Start the engine.
2. Raise the loader arms to the fully raised position.
3. Shut off the engine and remove the key.
4. Remove the pins securing the cylinder locks.
5. Place the cylinder locks on the posts on the
sides of the machine and secure with the pins.
6. Lower the loader arms.
Accessing Internal
Components
WARNING
Opening or removing covers, hoods, and
screens while the engine is running could
allow you to contact moving parts, seriously
injuring you.
Before opening any of the covers, hoods, and
screens, shut off the engine, remove the key
from the key switch, and allow the engine to
cool.
Opening the Hood
1. Loosen the hood-locking screw
Figure 32
1. Hood-locking screw
2. Hood-latch lever
(Figure 32)
g031215
3. Hood
2. Turn the hood latch clockwise
3. Lift up on the handles and swing the hood up
(Figure 32).
4. Secure the prop rod.
Closing the Hood
1. Lift up on the tab securing the prop rod
33)
1. Prop-rod tab
2. Lower the hood and secure it by pushing down
on the front of the hood until it locks in place.
3. Tighten the hood-locking screw to secure the
latch (Figure 32).
Opening the Rear-Access Cover
1. Remove the fastener
1. Fastener
2. Lift the rear-access cover up to access the
internal components
3. Lower the rear-access cover and install the
fastener to close the cover.
27
(Figure 32).
Figure 33
(Figure 34).
Figure 34
(Figure 34).
(Figure
g031216
g031217