Hitachi 3090 G2 Hardware Reference Manual page 67

9. Disengage the cable ties from the shell of the MFB by squeezing the tabs at the base
of the cable ties.
10. Once all cable ties have been disconnected, disconnect the cable connectors from
the mating MFB connectors by pressing the connector retainer tabs.
11. Once all internal cables have been disconnected, remove the MFB. Turn it upside
down and place it on a flat work surface.
12. Open the box that contains the replacement MFB module. Remove the module and
orient it so that the module cover labels face down. This will protect the sheet metal
tabs on the bottom side of the module (see next illustration).
13. Place the labeled cover down on a flat work surface and remove the module from
the ESD shielding bag.
Chapter 6: Replacing server components
Hitachi NAS Platform 3080 and 3090 G2 Hardware Reference
Replacing the FPGA board
67