Advertisement
QUICK START GUIDE
Warning: Shock Hazard and Equipment Damage - Equipment and subassembly ports
1.
are suitable for connection to intra-building or unexposed wiring or cabling;
2.
can be connected to shielded intra-building cabling grounded at both ends.
Step 7 - Verify Shelf ID Setting
•
Set Shelf ID to 00 to operate without a system controller.
•
Set Shelf ID to 01 through 98 are read by a controller if present.
•
Set Shelf ID to 99 to perform Lamp Test.
Step 8 - Install Modules
1.
Verify Module Type - see Information: 8 port Module Compatibility
2.
Open latch.
3.
Insert module into Shelf.
4.
Close latch.
Step 9 - Initial Start Up
1.
Verify that all connections are complete and secure.
2.
Turn on the DC input breaker.
Modules automatically start up and scan outputs for loads. Circuits with loads are turned ON, circuits without
loads are turned OFF.
Information: LEDs and Alarm
Condition
Class 2 Circuit ON
Class 2 Circuit OFF
Class 2 Circuit Over Current/Shorted
Class 2 Circuit Fail (1 or more)
Input Voltage Very Low
Input Voltage Out of Range
Reversed Input Polarity
Alarm Card Fail
Internal Shelf Comm Fault3
GP Comm Fault
Condition
Circuit - OFF
Circuit - ON - Over Current
Circuit - Fail
Comm Fault <-> Alarm Card
Module Fail
Input Voltage Out of Range
Input Voltage Very Low or
Reversed Polarity
Page 4
© 2021 ABB. All rights reserved.
Shelf LED
OK
ALM
G
OFF
G
OFF
OFF
Y
OFF
R
OFF
OFF
OFF
Y BLINK
R BLINK
OFF
Y BLINK
OFF
R
OFF
G
OFF
R BLINK
Module LEDs
Module OK LED
1
Priority
LED
G
3
Y
1
R
4
R BLINK
1
R
2
Y BLINK
OFF
Shelf Alarm
-
Alarm
Alarm
Alarm
Alarm
Alarm
Alarm
Alarm
Alarm
Module Circuit
LEDs
2
OFF
Y
R
Per Circuit Condition
OFF
OFF
OFF
Latch
Alarm Card
Circuit LEDs
Advertisement
