Table of Contents
Advertisement
5.1.3
CONFIGURING BASIC FOR AUTO-START OPERATION
North Star HSIO-4
1.
With the diskette still in drive one,
restart the computer with the reset switch.
The word READY should appear on the screen.
2.
Type the following commands:
10
CHAIN "HSIOTEST"
BYE
+SF BASIC E00 (Standard Origin of 5.2 DOS and BASIC
+JP E00
10 OPEN #1 %1, "BASIC"
20 WRITE #1 % 15 , & 0 , NOENDMARK
30 CLOSE #1
RUN
3.
Restart the computer with the reset switch.
The HSIO-4 test sign-on prompt ("North Star
HSIO-4 Test") should appear on the screen.
If this sign-on prompt does not display,
check to make sure that the procedures in
Section 5.1. have been properly executed.
68
User/Technical Manual
Advertisement
Table of Contents
