!2 High speed serial interface
This connector is used when an external numeric key or
memory device is connected. Attach the cover when
not using the connector.
Note: Refer to the dealer for available external devices.
"High speed serial interface" is only used in the stand-
alone mode, and the stand-alone mode has not been
evaluated by UL.
I Rear View
Remove the cable hole cover by loosening the screws with a Phillips screwdriver.
16
Cable hole cover (Used if you lay
cables along a wall surface)
Tamper detection lever
!2 High speed serial interface
Reinforcing screw holes
Mounting screw holes
Cut off from the rear cover.