A: Fully Automatic Wireless Flash Shooting - Canon 0585C006 Instruction Manual

a: Fully Automatic Wireless Flash Shooting

This section describes basic fully automatic wireless shooting when
using a device (sender) equipped with the optical transmission wireless
sender function and a 430EX III-RT/430EX III set as a receiver unit.
For details on optical transmission wireless flash shooting and sender unit
operation procedure, refer to the instruction manual of the sender device.
Set the sender unit.
1
Set the device with the sender

function as the optical transmission
wireless sender unit.
Set the receiver unit.
2
Set the 430EX III-RT/430EX III to be

controlled wirelessly from the sender
unit as the receiver unit (p.73).
A, B, or C can be set as the firing

group.
Set a channel.
3
If the channels of the sender unit and

receiver unit are different, set them to
the same number (p.73).
Position the camera and the
4
flash.
Position them within the range shown

on page 72.
Set the flash mode to <a>.
5
Set the flash mode of the sender unit

to <a>.
The receiver unit is set automatically

to <a> during shooting by
control from the sender unit.
Check that the firing group control is

set to <8> (no flash ratio control is
set: _).
75