Table of Contents
Advertisement
Panasonic Digital Business System - Programming Manual
April 1997
Auto line disconnect time
0#: No Loop down signal
1#: Loop down signal after 50 ms
2#: Loop down signal after 100 ms
3#: Loop down signal after 150 ms
4#: Loop down signal after 200 ms
5#: Loop down signal after 250 ms
6#: Loop down signal after 300 ms
7#: Loop down signal after 350 ms
8#: Loop down signal after 400 ms
9#: Loop down signal after 450 ms
10#: Loop down signal after 500 ms
11#: Loop down signal after 550 ms
12#: Loop down signal after 600 ms
13#: Loop down signal after 650 ms
14#: Loop down signal after 700 ms
15#: Loop down signal after 750 ms
This specifies the pause time before sending out the LOOP DOWN signal to cut off an exchange
line when the line is busy or exchange line call is on hold following reception of an external
disconnect signal.
Note: Setting this step to 1 will allow the DBS to recognise Calling Party Clear (CPC) signals from
the exchange. This should be set when the Voice Announce Unit is installed on the lines
ringing to the VAU. Otherwise the VAU will not clear down correctly if a caller hangs up.
Note: CPC is not available on all exchanges
Type of PBX recall signal
0#: No recall
1#: Enable time break
2#: Enable earth recall
This sets each exchange line to time break, earth or no recall.
Related step
FF1 3# 16# , Exchange line disconnect time REDIAL/flash
FF1 3# 17# , PBX recall time - earth recall
FF1 3# 18# , PBX recall time - time break recall
FF2-1#-(01-48)#-15#-(0 -15)#
FF2-1#-(01-48)#-16#-(0-2)#
77
Issue 15
[DISCONNECT TIME]
[FLASH TIMED SET]
2.x
2.x
Advertisement
Table of Contents
