Craftsman C950-52546-0 Operator's Manual page 13

Stop the Snowthrower
1. Release the auger control lever (B, Figure 3).
2. Release the traction control lever (G).
3. Move the throttle control lever (F, Figure 8) to SLOW and
then to the STOP position.
4. Turn the ON/OFF key (D) to the OFF position.
5. Remove the key.
6. Keep the key out of the reach of children.
7. After the engine stops, turn the fuel shut-off valve (G) to
the closed position.
Easy Turn™ Traction Control
For easy turning when using the snowthrower, squeeze the
EasyTurn™ lever.
Engaging the Easy-Turn lever releases the left or right
traction wheel, but allows the opposite wheel to continue
driving. Figure 5 shows the left Easy-Turn lever engaged.
Releasing the Easy-Turn lever automatically engages both
drive wheels for full traction (see Figure 6).
NOTE: The Easy-Turn will be more difficult to activate under
a heavy load. Activate the lever before beginning a turn.
5
2
1
Check the Oil
NOTE: The engine was shipped from the factory filled with
oil. Check the level of the oil. Add oil as needed.
1. Make sure the unit is level. Use a high quality detergent
2. Remove the oil fill cap/dipstick (A, Figure 7) and wipe
2
1
3. Insert the oil fill cap/dipstick and turn clockwise to
4. Remove the oil fill cap/dipstick and check the oil.
NOTE: Do not check the level of the oil while the engine
runs.
5. If necessary, add oil until the oil reaches the FULL mark
6. Tighten the oil fill cap/dipstick securely each time you
NOTE: For extreme cold operating conditions of 0°F (-18°C)
and below, use a synthetic 5W30 motor oil for easier start-
ing.
NOTE: S.A.E. 5W30 motor oil may be used to make starting
easier in areas where the temperature is 20°F (-7°C) to 0°F
(-18°C). Synthetic 5W30 is acceptable for all temperatures.
DO NOT mix oil with gasoline. See Chart for oil recom-
mendations.
6
oil classified "For Service SF, SH, SJ, SL, or higher".
with a clean cloth.
7
A
tighten.
on the oil fill cap/dipstick. Do not add too much oil.
check the oil level.
FULL
13
en