Installation; Installation Sequence - NorthStar NS3300 AutoPilot Installation Manual

3 Installation

Warning: Correct installation is critical to the performance of the unit. It is vital to read this manual and the
documentation that comes with the other parts before starting installation.
Warning:
Warning: Ensure that any holes that you cut will not weaken the boat's structure. If in doubt, consult a qualified
boat builder.

3-1 Installation sequence

The recommended installation sequence is:
1 Read this manual and the documentation that comes with the other parts.
2 Plan the installation: select where the equipment and wiring will be installed (see section 3-2).
3 Install the MCU600 (see section 3-3).
4 Install the steering drive and wire the heavy duty and light duty power supplies (see section 3-4).
5 Install the rudder feedback unit (see
6 Install the compass (see section 3-6).
7 Install the gyro (see section 3-7).
8 Install the display unit and any other marine instruments that will be used with the PILOT 3300 system (see
9 Carry out the dockside setup (see section 4).
10 Carry out the sea trials (see section 5).
If you are unsure where a part should be installed, mount and wire the part temporarily, without cutting holes in
the boat. After the sea trials have been completed, install and wire the part permanently.
Reference Manual
The MCU600 is not waterproof. Mount the unit in a dry place.
The PILOT 3300 system display unit is waterproof.
The compass, gyro and rudder feedback unit are completely waterproof.
section 3-5).
section 3-8).
9