Reference Manual
Installation
1 Find a suitable location for the unit as described above.
2 Mount the unit with the three screws provided. Use a level to ensure the unit is vertical to
within 10°.
3 Wire the cable back to the MCU600, following the wiring guide (see
section 3-2-2).
Note
If you move the compass with respect to the gyro while the power is on, wait for the
heading to stabilize.
Less than 10° 10°
Less than
10° 10°
MCU600
Holes in the bulkheads
must be at least 18.5 mm
(0.73 in) diameter.
Plug connector into the Compass/HS socket
21