Installation
1 Find a suitable location for the unit as described above.
2 Mount the unit with the three screws provided. Use a level to ensure the unit
3 Wire the cable back to the MCU600, following the wiring guide (see section 3-2-2).
Note
Reference Manual
is vertical to within 10°.
If you move the gyro with respect to the compass while the power is on, wait for the heading to stabilise.
Less than
Less than
10° 10°
10° 10°
MCU600
Holes in the bulkheads
must be at least 18.5 mm
(0.73") diameter.
Plug connector into the Gyro socket
23