Installation
1 Find a suitable location and arrangement for the unit as described above.
2 Choose, assemble and fit a suitable rudder linkage.
3 Fit the unit as shown below:
4 Wire the cable back to the MCU600, following the wiring guide (see section 3-2-2).
Reference Manual
Rotate base so arrow on arm
points near centre line on
Set rudder
If necessary, mount
base. Fit two screws provided
amidships.
base on block to
loosely in middle of slots.
set height.
Join coupling to
rudder linkage.
If necessary, cut connecting
rod at this end, then replace
coupling and lock nut.
Rotate base so arrow on
arm points to centre line
on base. Fit third screw pro-
vided, tighten all screws.
Ensure rudder is
amidships.
Snap end into
correct hole in arm.
MCU600
Holes in the bulkheads
must be at least 18.5 mm
(0.73") diameter.
Plug connector into the RFU
socket
19