Table of Contents
Advertisement
6
Functions
6.1
LED Indications
LED indication
Green
Green/red flashing
Red
6.2
LED Indications for StatusBus
LED indication
Double flash, red
0.11/0.2/0.11/0.67 s,
on/off/on/off
Double flash, green
0.11/0.2/0.11/0.67 s,
on/off/on/off
Off for 5 sec, then
flickering flash 0.07/1.9
s, on/off
Scours with stress
flash.
Scouring cycle: 0.8/0.4
s, on/off
Flash frequency:
0.02/0.03 s, on/off
6.3
Information output signal attributes
The information output of the unit is set either high or low according to the following table:
Button status
Button actuated/pressed
Button released/not pressed
The delay for switching the information output signal:
Information output signal switch
Delay
2TLC172163M0201 Rev.F
Description
DYNlink input signal, button
released/not pressed
DYNlink input open or 0 VDC,
button released/not pressed
Button actuated/pressed
Description
Device in StatusBus mode, off.
"Ready slave" address 0
Device in StatusBus mode, on.
Address 0
The flashing usually lasts for 1-4
seconds during the addressing
process.
At the command from StatusBus
Master
High -> Low
~ 60 ms
DYNlink state
OK
Interrupted before this
unit
Interrupted in this unit
Status
Device not addressed.
Device not addressed.
If the condition lasts for
more than 4 seconds:
Device failure when
addressing, change
address.
Device identification.
Information output signal status
Low
High
Low -> High
~ 10 ms
10
Advertisement
Table of Contents
