Zero Point Adjustment - Siemens SITRANS F Operating Instructions Manual

Device menus
Simulation (online dialog)
Loop Test (online dialog)
Access Management
Reset (online dialog)
Configuration Flag Reset (online dialog)
HART Communication (online dialog)
Table 6- 2
View menus
Process Variables (online dialog)
Device Diagnostic (online dialog)
Toolbar (online dialog)
Status Bar
Update
6.4.10

Zero point adjustment

The flowmeter system is optimized through a zero point adjustment.
Performing a zero point adjustment
NOTICE
Preconditions
Before a zero point adjustment is initiated, the pipe must be flushed, filled and at an
absolute flowrate of zero preferably also at operating pressure and temperature.
1. Flush out any gases and obtain stable temperature conditions by running flow at
SITRANS FC430 with HART
Operating Instructions, 03/2012, A5E03361511-01
View menus
operational conditions for minimum 30 minutes.
Description
Simulation of process values, alarms, and inputs/outputs
(channels 2 to 4)
Simulation of current output (channel 1)
Possibility to upgrade access level from "user" to "expert"
and to change PIN code for "expert" level
Resets device to default settings or restarts device
Commands reset the configuration flag
Number of preamples
Description
Shows all process values
Shows all diagnostics information (alarms and
diagnostics parameters)
Shows/hides the toolbar
Shows/hides the status bar
Updates the content of the active window
Commissioning
6.4 Commissioning with PDM
87