Care And Maintenance - DeWalt DXAELJ16 Instruction Manual

Make sure all the unit functions are turn off when the unit is being
recharged or stored.
TYPE C PORT AND TYPE A USB PORT FAULT CONDITIONS
When the Type C and/or Type A USB Ports are in use, the unit will
monitor for the following fault conditions (on both Ports):
• If a Low Battery Voltage Fault occurs, only one Battery Status
LED Indicator flashes for 30 seconds before automatic shut down
occur.
• If an Overload Fault or a Short-circuit occurs, the unit will
automatically shut down immediately.
• If the battery of the unit overheats or is too cold, the
output of the USB ports automatically shut down immediately. The
Battery Status LED indicators light for one minute before the unit
automatically shuts down.
In any of these cases, disconnect the USB-powered device
immediately.
– Make sure the unit does not need to be recharged.
– Allow the unit to cool down for several minutes before attempting
to use the USB Ports again.
– If a fault occurs again, make sure that the total draw of all USB
devices plugged into the USB Ports does not exceed 3.1A (5V).
– If an individual USB device is within specifications and the fault
occurs, have the USB device checked for malfunction and do not
continue to use it with these USB Ports.
Notes:
This unit's USB Ports do not support data communication. They only
provide power to external USB-powered devices. The USB Ports provide a
total of 3.1A (5V).
Some USB-powered household electronics may not operate with this USB
port. Check the manual of the corresponding electronic device (including a cell
phone, tablet, etc.) to confirm that it can be used with this type of USB port.
OPERATING THE 120V AC/USB CHARGING
ADAPTER'S USB PORT
Plug the 120V AC/USB Charging Adapter into a (powered) standard
North American 120 volt 60Hz outlet. Simply plug a USB device into
the USB outlet and operate normally.
WARNING – To reduce the risk of injury or property damage:
Always plug the 120V AC/USB charging adapter to the standard
North American 120 volt 60Hz outlet before plugging any devices
into it.
OPERATING THE 12V DC/USB CHARGING
ADAPTER'S USB PORT
Plug the 12V DC/USB Charging Adapter into a vehicle's 12 volt DC
accessory outlet or other functioning 12 volt DC power source. The
LED indicator on the 12V DC/USB Charging Adapter LED Indicator
will light green to show that it is properly connected. Simply plug a
USB device into the USB outlet and operate normally.
Note: Some vehicles require that the ignition be switched to the
accessory outlet position in order to power the accessory outlet.

Care and Maintenance

WARNING: To reduce the risk of injury, turn the unit off and
disconnect it from any power source before installing and removing
accessories, before adjusting or when performing maintenance. An
accidental start-up can cause injury.
Never submerge this unit in water. Dirt and grease may be removed
from the exterior of the unit using a cloth or soft non-metallic brush.
Never let any liquid get inside the unit; never immerse any part of the
unit into a liquid.
WARNING: Shock hazard. Disconnect the AC extension cord
before cleaning.
14