DeWalt DXAELJ16 Instruction Manual page 12

CHARGING/RECHARGING USING THE 12V DC/USB
CHARGING ADAPTER
IMPORTANT: Always connect the 12V DC/USB Charging Adapter
to the 12 volt DC power source (using the USB Charging Cable)
BEFORE connecting it to the unit.
1. Make sure the Power Button is turned off (the Battery Status LED
Indicators are not lit).
2. Insert one end of the USB Charging Cable into the 12V DC/USB
Charging Adapter.
3. Insert the 12V DC/USB Charging Adapter into a vehicle's 12 volt
DC accessory outlet or other functioning 12V DC power source.
The LED indicator on the 12V DC/USB Charging Adapter will
light green when it is properly plugged into the 12 volt DC power
source.
Note:
Some vehicles require that the ignition be switched to the
accessory outlet position in order to power the accessory outlet.
4. Lift up the protective cover of the USB ports. Insert the other end
of the USB Charging Cable into the unit's Type A USB port.
5. The blue Battery Status LED Indicators will gradually light up (left
to right) to indicate the unit is charging.
6. Charge until the unit automatically shuts down. Unplug the 12V
DC/USB Charging Adapter from the 12 volt DC power source,
then disconnect the USB Charging Cable from the 12V DC/USB
Charging Adapter, and then from the unit's Type A USB port.
7. Press the Power Button to turn the unit on. When all three blue
Battery Status LED Indicators light, the unit battery is fully charged.
8. Store the 12V DC/USB Charging Adapter and USB Charging
Cable in a safe place.
CHARGING/RECHARGING USING THE USB CHARGING
CABLE AND A DEVICE WITH A USB POWER PORT (NOT
SUPPLIED)
IMPORTANT: Always connect the USB Charging Cable to the
external device's USB power port BEFORE connecting it to the unit.
A 2A USB power source is required in order to recharge the unit.
1. Make sure the Power Button is turned off (the Battery Status LED
Indicators are not lit).
2. Insert one end of the USB Charging Cable into an external
device's functional USB power port.
3. Lift up the protective cover of the USB ports. Insert the other end
of the USB Charging Cable into the unit's Type A USB port.
4. When the unit is properly connected, the blue Battery Status LED
Indicators will gradually light up (left to right) to indicate the unit is
charging.
5. Charge until the unit automatically shuts down.
6. Disconnect the USB charging cable from the device's USB power
port and the unit.
7. Press the Power Button to turn the unit on. When all three blue
Battery Status LED Indicators light, the unit battery is fully charged.
8. When charging is complete, store the USB Charging Cable in safe
place.
OPERATING INSTRUCTIONS
JUMP-STARTING USING THE SMART CABLES
Battery Clamp Connection Precautions
• Connect and disconnect the battery clamps only after unplugging
the power source.
• Make sure the engine is not running when connecting or
disconnecting the battery clamps.
11