4.
Checking the input wiring
Check the input wiring by using the input display LEDs or the monitoring function of the
programming tool.
5.
Trial operation
1. Set the mode switch to "RUN" and check that the "RUN" LED is turned on.
2. Check the sequence operation.
6.
Debugging
1. If there is an error in the operation, check the project using the monitor function of the
programming tool.
2. Correct the project.
7.
Saving the project
Save the created project.
WUME-FP7CPUH-09
5.1 Before Powering On
5-3