BREDABEDS URBAN MURPHY Assembly Instructions Manual page 27

Chapter 4: Assembling the Bed Face Panel unit.
For video instructions of this chapter, visit: https://breda.us/frame
STEP 3
Critical Step
to insert screws. When attaching screws, attach the 4
corners fi rst, which will help keep the frame aligned.
The position of the frame over the doors is crucial,
so double check alignment as you insert screws.
Additionally, DO NOT skip holes.
Full, Queen and King beds: Before attaching the frame,
make sure the doors are pushed together so there's
no gap between the doors and they are even on
the ends. With the doors properly aligned, add tape
down the seam to keep them in position.
Failure to leave a 1/2" between the doors and frame on the mechanism end
Do not pre-drill holes for the screws otherwise they will not hold properly.
Screws should be inserted directly into the wood panels.
Once the 4 corners are attached, check the measurements again to verify the frame
is centered correctly on the sides, verify the 1/2" along the mechanism end, the
doors are pushed together and that the doors are properly aligned on the ends.
STEP 4
METROPOLITAN MURPHY BEDS: To prevent screws
from poking through the thin areas, you
measure accurately. Additionally,
the previously marked screw-free
Bed Size
Twin & Full
Twin-XL, Queen
and King
Position the frame 1/2" from
"Mechanism End" and centered
along the left and right sides.
Attach frame to doors using
screws from hardware card #7.
We recommend using a bit holder
will cause misalignment later during assembly.
Position steel support stiff eners according
to the dimensions listed in the table
below. Measurements are from either the
"Mechanism End" or "Frame End". Take
care not to cover handle holes. Attach
with screws from hardware card #7.
Steel Stiffener Spacing
19" - 38" - 57" (every 19" center-to-center)
20 ¼" - 40 ½" - 60 ¾" (every 20 ¼" center-to-center)
FIG. 4G - OVERHEAD VIEW
must
do not screw into
zone.
FIG. 4H - OVERHEAD VIEW
27