Broadcast Encryption - Motorola APEX1000 Installation And Operation Manual

The following table lists the individual characteristics of each encryption mode:
Mode
Broadcast
Encryption
Common Tier
Encryption
Session VOD
Encryption

Broadcast Encryption

Broadcast Encryption in Manual Routing Mode
The APEX1000 supports the processing of linear broadcast services with encryption:
IRDs
(Analog)
IRDs
(IP output)
IRDs
(ASI output)
CAUTION You must convert all ASI outputs from IRDs or encoders to GigE before sending them to
the APEX1000. As shown in the preceding graphic, you can perform this conversion
using a SEM v8. Additionally, the Motorola AGB240 (ASI to GigE Bridge) can also be
used to convert ASI into GigE.
Overview • Supported Encryption Types
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
Application
Broadcast/Linear content DAC by means of the
UDP Port Mapped VOD,
Session Controlled, and
Manual Route
VOD Session Controlled
in MHA mode only
MPEG
NTSC
over GigE
Encoders
SPTS/MPTS over GigE
ASI SEM v8
over GigE
MPEG
Encoders
Digital IRDs
Content
Servers
RMD Source/Interface
RDS Interface Protocol
Configured statically in
the APEX1000
SVM/ERM by means of
the ERMI-2 interface
Configuration and
Status Monitoring
SPTS
Switched and/or
Routed
IP/GigE Network
MPEG over
GigE (and
MPTS
MPTS
over GigE
Trans Rate Mux/
Groomer/
Ad Insert
Access Characteristics
Unique tier(s) and copy
protection are applied to
each service
Single tier and copy
protection are applied to
all streams
Unique tier and copy
protection settings are
applied to each service
APEX EM
(SNMP)
48 QAMs
8-port port
APEX
IGMP)
Rights Data
Server
Interface
DAC
B
22