Motorola APEX1000 Installation And Operation Manual page 279

5. If the input program is pre-encrypted, and pre-encryption has been selected, then the
ECM PID is also remapped or remultiplexed to the specified output stream.
Additionally, the PIT PID is extracted and reinserted into the output stream (the
output program number in the PIT is updated).
6. If the output program is being encrypted (input program is not pre-encrypted), then
the APEX1000 will mark the component PIDs with the appropriate scrambled control
bit settings and encrypt the payload of the component PIDs. Additionally, ECM
messages such as the PRK and WKE are inserted.
7. The output PAT and PMT are updated and inserted to contain the appropriate PID
and program number references.
Item
Input Interface
Input UDP
Input Multicast
Input Source
Output TS
Input Service
Encryption
Mode
Status • Reports
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
Output Program Status window field definitions
Definition
Specifies a GigE port (1 – 4) or Enet port (1 – 2) as the input interface.
Identifies the input UDP port for a service (UDP port opened to receive service).
Shows the Receive Multicast IP Address.
Shows the Source IP Address.
This column replicates the transport stream-to-output interface selections made in the
APEX1000 Output Transport Stream Configuration window.
This is the output stream that the input program is being mapped to.
Indicates the input service as clear or pre-encrypted. Only applicable when the program
mapping has been configured to check for pre-encryption.
Encryption mode of the program. This is the configured encryption mode based on
either the user-configured CTE encryption mode, or the RMD information received for
Broadcast encrypted services.
•
Full
•
FWK
•
FPK
•
Unencrypted/Clear
•
Clear
•
Pre-Encrypted
B
261