Table of Contents
Advertisement
Item
Enable PSIP
Processing
Message
Insertion
Period (ms)
DST Settings Use this area for defining the DST values for In/Out Month, Day, and Hour.
Configuration • PSIP Configuration
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
PSIP Configuration window field definitions
Definition/Range
Use this area to enable PSIP for the output transport stream. To enable a transport
stream for PSIP, select the desired line(s) and click >>>. (Only applicable to manual
route OTSs.)
IMPORTANT: PSIP processing also requires that Time Source be set to SNTP
The default is Disabled.
Note: You must click Apply to enable the transport stream.
Shows the insertion rate for each PSIP table (global).
Default values are:
PSIP Table
MGT – Message insertion period in milliseconds for
the PSIP Master Guide Table (MGT). This message is
sent on the PSIP Base PID before the start of
insertion of the first packet of the message.
STT – Message insertion period in milliseconds for
the PSIP System Time Table (STT). This message is
sent on the PSIP Base PID before the start of
insertion of the first packet of the message.
CVCT – Message insertion period in milliseconds for
the PSIP Cable Virtual Channel Table (CVCT). This
message is sent on the PSIP Base PID before the
start of insertion of the first packet of the message.
RRT – Message insertion period in milliseconds for
the PSIP Rating Region Table (RRT). This message is
sent on the PSIP before the start of insertion of the
first packet of the message.
Event Information Table – Insertion period in
milliseconds for the PSIP EIT messages.
EIT-0
EIT-1
EIT-2
EIT-3
B
Default Insertion
Rate
150 ms
1000 ms
400 ms
60000 ms
Default Insertion
Rate
500 ms
3000 ms
10000 ms
10000 ms
98
Advertisement
Table of Contents
