Communication Port - Mitsubishi Electric KD Series User Manual

4-1 Communication port

4-1-1 Master and slave port for communication
A3(KD6R309MX/MX-NL)
Master port
A1(KD6R617MX/MX-NL)
Master port
A0(KD6R926MX/MX-NL)
TM-XG537C
D1
D1
Master port
D1
COPYRIGHT © 2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
【 Control method 】
This product receives the communication control and a
synchronization signal through Communication port.
【 Control through Communication port 】
・ Input external synchronization signal (CC1)
・ Communication (UART)
【 Communication port connectors 】
Each product has each Communication port connector as
described on the left. Communication port connector is D1.
【 Line synchronization signal 】
In the case of external sync. mode , the sync. signal
inputted from CC1 signal line of Communication port is
distributed into other modules (Camera Link® channels).
Therefore All modules are synchronized by same sync. signal.
【 Internal synchronization mode 】
The sync. signal, generated by the internal control circuit, is
distributed into other modules. Therefore All modules are
synchronized by same lines.
【 Remarks 】
1)This product doesn't accept communication signal through
other than Master port.
2)Make sure the connector assignment on a grabber board
you would use first.
Camera Link® is a registered trademark of AIA(Automated Imaging Association)
53