Remote Control - Eberg Qubo Q40NE Instruction Manual

EN QUBO
and run the Tuya Smart Life application on the smartphone. Then, select the device search option
in the application. The air conditioner at this point must be connected to the power supply, but not
turned on (in standby mode). Then press and hold the SLEEP button for at least 3 seconds. After
connecting to the WiFi network, the device beeps. There is no indicator showing the WiFi connection
status on the display, but after emitting a beep, the device should connect to the WiFi network. This
will be visible in the app on your phone. If connection fails, uninstall and reinstall the application and
search for the device again.
More information on WiFi control can be found in the mobile application manual attached to this
user manual.
11. ALARM
When the water tank is full, the display will show error code E4. To resume operation of the unit,
remove the rubber plug from the condensate drain socket and empty the condensate tank. E4 will
disappear when the tank is empty. Restart the device to resume normal operation.

REMOTE CONTROL

Cooling
Heating
Dehumidifying
Sleeping
Timer ON/OFF
Temperature
Swing
High speed
Medium speed
Low speed
CONTROLLING THE DEVICE OPERATION BY A REMOTE CONTROL
When a remote control signal is transmitted, the transmit icon in the display will flash once to
indicate that the signal has been transmitted. Odbiornik sygnału pilota
1. Remote control signal receiver
29
www.eberg.eu