Table Of Contents - Toro ReelMaster 01005 Operator's Manual

Introduction
Read this information carefully to learn how to operate and
maintain your product properly and to avoid injury and
product damage. You are responsible for operating the
product properly and safely.
You may contact Toro directly at www.Toro.com for product
and accessory information, help finding a dealer, or to register
your product.
Whenever you need service, genuine Toro parts, or additional
information, contact an Authorized Service Dealer or Toro
Customer Service and have the model and serial numbers
of your product ready. The two numbers are stamped on a
plate which is located on the cross tube. Write the numbers
in the space provided.
Model No.
Serial No.
This manual identifies potential hazards and has safety
messages identified by the safety alert symbol (Figure 1),
which signals a hazard that may cause serious injury or death
if you do not follow the recommended precautions.
1. Safety alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical information
and Note emphasizes general information worthy of special
attention.
© 2014-The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Figure 1
Contents
Safety ........................................................................... 3
Setup ............................................................................ 4
1 Removing the Mower from the Carton ..................... 4
2 Checking the Wheel Hubs and Installing the
Wheels ............................................................... 4
3 Checking the Gear Case Oil.................................... 5
4 Checking the Reel Bearings and Mower
Fasteners ............................................................ 5
5 Parallel the Bedknife to the Reel .............................. 6
6 Setting the Height Of Cut....................................... 7
Product Overview .......................................................... 8
Specifications ......................................................... 8
Operation ..................................................................... 8
Adjusting the Bedknife to the Reel for Light
Contact .............................................................. 8
Operating Tips........................................................ 9
Causes of Poor Quality of Cut ................................... 9
Maintenance .................................................................11
Lubrication............................................................11
Adjusting the Reel Bearings .....................................11
Grinding ...............................................................11
Lapping ................................................................12
Replacing the Bedknife ...........................................12
Adjusting the Reel, Roller and Wheel Bearing
........................................................................13
Servicing the Roller.................................................13
2
Contact us at www.Toro.com.
Printed in the USA.
All Rights Reserved