Troubleshooting - Toro 22618 Operator's Manual

Troubleshooting

Problem
The engine does not start.
The engine runs rough.
The splitting wedge does not move.
The splitting wedge moves slowly.
Possible Cause
1. The engine On/Off switch is in the O
position.
2. The fuel-shutoff valve is closed.
3. The choke is open.
4. The fuel tank is empty.
5. The throttle is not in the F
6. The spark plug wire is loose or
disconnected.
1. The choke is closed.
2. The air filter is clogged.
3. The fuel line is clogged.
4. There is water or contaminants in the
fuel.
5. The spark plugs are worn or have
buildup on the electrodes.
1. The hydraulic-fluid level may be low.
2. The control valve or pump is blocked
or damaged.
1. The engine speed is set on idle.
2. The hydraulic fluid is contaminated.
3. The hydraulic pump, cylinder, or
directional valve is damaged.
30
1. Move the switch to the O
FF
2. Open the fuel-shutoff valve.
3. Close the choke when starting a cold
engine.
4. Fill the tank with fresh fuel.
position. 5. Move the throttle to the F
AST
6. Check the electrode gap and clean or
replace the spark plug.
1. Open the choke.
2. Clean or replace the air filter.
3. Clean the sediment cup.
4. Drain the fuel tank and fill it with fresh
fuel.
5. Check the electrode gap and clean or
replace the spark plug.
1. Add hydraulic fluid.
2. Contact your Authorized Service
Dealer.
1. Move the throttle to the F
2. Change the hydraulic fluid and filter.
3. Contact your Authorized Service
Dealer.
Corrective Action
position.
N
position.
AST
position.
AST