Starting The Engine; Shutting Off The Engine; Changing The Rail Position - Toro 22618 Operator's Manual

Starting the Engine

1. Turn the engine On/Off switch to the O
(Figure 5).
2. Move the fuel valve to the O
7).
1. Choke lever
2. Fuel valve
3. Move the choke lever to the C
(Figure 7).
Note:
A warm or hot engine may not require
choking.
4. Move the throttle lever to the F
(Figure 7).
5. Pull the starter handle lightly until you feel
resistance, then pull the handle briskly
7). Return the starter handle gently.
6. After the engine starts, gradually move the
choke lever back to the O
engine stalls or hesitates, move the choke back
to the O position again until the engine warms
N
up. Then move it to the O

Shutting off the Engine

1. Move the throttle lever to S
2. Turn the engine On/Off switch to the O
position.
3. Move the fuel valve to the C
N
position
PEN
Figure 9
3. Throttle lever
4. Recoil-start handle
position
LOSED
position
AST
(Figure
position. If the
FF
position.
FF
position.
LOW
position.
LOSED

Changing the Rail Position

position
WARNING
(Figure
The rail is heavy and can suddenly fall onto
the machine frame if you release the handle
when raising or lowering the rail.
Control the rail by the handle, and keep your
hands away from the machine frame and
pinch points when raising or lowering the rail.
Raising the Rail to the Vertical
Position
You can rotate the rail and use it in the horizontal or
vertical position.
1. Park the machine on level ground, adjust the
jack stand to ensure that the machine is level,
and shut off the engine.
2. Chock the front and back of the tires to prevent
the machine from moving.
3. Remove the lock pin
4. Rotate the rail so that it is vertical, against the
base of the machine
g205921
5. Rotate the vertical lock lever to the closed
position to secure the lower rail in place
10).
FF
12
(Figure 10).
(Figure 10).
Figure 10
(Figure
g393407