Table of Contents
Advertisement
9.
Install the fuel filter in the bottom of the
carburetor
(Figure
10.
Align the O-ring into the groove in the sediment
cup and install the sediment cup to the fuel-valve
housing.
11.
Move the lever of the fuel valve to the O
position (all the way to the right) and check for
leaks. If it leaks, replace the O-ring.
30).
N
Drive System
Maintenance
Checking the Tire Pressure
Service Interval: Before each use or daily
WARNING
Failure to maintain correct tire pressure
may result in tire failure and loss of control,
resulting in property damage and serious
injury or death.
• Check the tire pressure frequently to
ensure proper inflation. If the tires are not
inflated to the correct pressure, they will
wear prematurely.
• Inspect the tire condition before towing
and after any operating accident.
The DOT tire information is located on the side of
each tire. This information gives load and speed
ratings. Replacement tires should have the same
or better ratings. For more information go to
http://www.nhtsa.gov/Vehicle+Safety/Tires.
1.
Visually inspect the tires for damage and wear
(Figure 31
and
1. Example of tire wear caused by underinflation
1. Example of tire wear caused by overinflation
2.
Ensure that the tires are inflated to 410 kPa (60
psi).
25
Figure
32).
Figure 31
Figure 32
g313616
g313615
Advertisement
Table of Contents
