Change The Warning Time - Canon varioPRINT 135 Series Operation Manual

Change the Warning Time

Change the Warning Time
Introduction
When operator interaction is required immediately or soon, the LED on the operator panel and
the operator attention light can warn you. This is a trigger that action is required immediately of
soon., for example load a required media type or empty an output location. You can define how
long in advance the warning message is displayed.
By factory default, the function [Warning in advance] is enabled and set to 10 minutes. Then the
dashboard starts to display the warning 10 minutes before an action becomes inevitable. If you
do not respond to the warning message, the printer will stop. Depending on the urgency of the
warning message, the LED on the operator panel and the operator attention light are orange or
red.
NOTE
You can only change the warning time when the [Warning in advance] function is enabled.
Illustration
[14] Change the warning time
Procedure
1.
On the control panel, touch [System] -> [Setup] -> [Warning time].
2.
Touch the - or + button to decrease or increase the warning time in steps of one minute. You can
set a time from 1 - 60 minutes.
3.
Press [OK].
48 Chapter 4 - Adapt Printer Settings to Your Needs
Canon varioPRINT 135 Series