Transaction Setups; Create A New Transaction Setup - Canon varioPRINT 135 Series Operation Manual

Transaction Setups

Create a New Transaction Setup

Introduction
For transaction printing, transaction setups are required. Transaction setups contain specific
settings for specific transaction jobs. You can create setups in the Settings Editor.
NOTE
This section describes how to create a transaction setup from scratch. If you want to create a
transaction setup that is very similar to an existing setup, you can also create a copy and make
changes afterwards. In this case you must select the setup and click [Copy].
Procedure
1.
Go to [Transaction printing] -> [Setups].
2.
Click the [Add] button.
A pop-up window appears.
3. Enter a name and description for the transaction setup, then click [OK].
4. Check the box next to the setup, then click [Open] to allow changes to the settings of the setup.
5.
Depending on the type of setup you created, click [IPDS setup] or [PCL setup].
NOTE
PCL is not available for all products. If you only have one license, the other PDL is not available.
You can change the settings:
• By group (click the pencil at the right-hand side of the group settings).
• By item (click the pencil behind the individual settings).
After you changed the settings of a transaction setup, you must load the transaction setup to
make the setup changes active (see
Canon varioPRINT 135 Series
Activate a Transaction Setup on page
Transaction Setups
199).
Chapter 6 - Carry Out Print Jobs 197