Canon varioPRINT 135 Series Operation Manual page 376

NOTE
Make sure that the registration sheets are placed correctly in the left-hand upper corner of the
glass plate. Make sure that the registration sheet on the glass plate is not curled or has dog ears.
You can use a stack of paper to reduce the curl.
You must close the ADF / cover for each scan.
The instructions for the paper path registration are the same as the instructions for the automatic
media specific registration.
4.
Repeat step 1, 2 and 3 for A3/Ledger.
The tray for the A3/Ledger bulk media is tray 3.
After you finish
If the front-to-back side registration is not satisfactory after you performed the paper path
registration, you must check the actual sheet length in the feed direction. The paper path
registration assumes nominal sheet length. If the actual sheet length differs from the nominal
sheet length, you must enter the actual sheet size (see
media registration is not correct you must perform the manual media registration for this media
Option 2 - Manual Media Registration Adjustment (Only Needed in Incidental Cases) on
(see
page 95).
NOTE
Previously performed media specific registration can influence the media registration for bulk
media. To verify the paper path registration, we therefore recommend to set all media specific
registration settings to 0.
Canon varioPRINT 135 Series
Perform a Paper Path Registration
Registration Values on page
Chapter 18 - Printer Operation Care (POC)
98). If the
375