What's Available Online; Getting Started With The Video Demonstration; Processor System Used For The Video Demo - Xilinx Virtex-6 FPGA ML605 Embedded Kit Getting Started

Introduction
•
•
•

What's Available Online

•
•
•

Getting Started with the Video Demonstration

This Virtex-6 Embedded Kit comes with a video demo available on the provided
CompactFlash card. You can run this demo before installing any additional tools to get an
overview of the features of the ML605 Evaluation Board using a MicroBlaze Processor
Subsystem in the Virtex-6 LX240T FPGA.

Processor System Used for the Video Demo

The provided demos use a pre-built Virtex-6 FPGA design
features:
•
•
•
•
•
•
•
•
•
•
10
• Software Development Kit (SDK)
• ChipScope™ Pro logic analyzer
Documentation
• ML605 Hardware Setup Guide
• UG730 Getting Started with the Virtex-6 FPGA ML605 Embedded Kit
• DS758 ML605 Embedded Kit MicroBlaze Processor Subsystem Data Sheet
• UG731 ML605 MicroBlaze Processor Subsystem Hardware Tutorial
• UG732 ML605 MicroBlaze Processor Subsystem Software Tutorial
Reference Designs and Demonstrations
• Base MicroBlaze Processor Subsystem
• Video Demo
Reference designs, demonstrations, documentation, and applications delivered on
USB Flash drive to get started quickly
License for ISE Design Suite 12.1 Embedded Edition
• http://www.xilinx.com/getproduct
• http://www.xilinx.com/tools/faq.htm
Embedded Kit home page with Documentation and Reference Designs
• http://www.xilinx.com/v6embkit
Technical Support
• http://www.xilinx.com/support/
MicroBlaze soft processor
External DDR3 Memory Interface
External Flash Memory Interface
On-chip Memory (Block RAM)
Integrated Tri-Mode Ethernet MAC (TEMAC)
UART (connected from ML605 board via the USB-UART connector)
Interrupt Controller (Intc) and Timer
CompactFlash Interface (System ACE™ technology)
GPIO (LEDs, LCD, Switches)
Video Pipeline DSP Cores
www.xilinx.com
(Figure 1) with the following
ML605 Getting Started Guide
UG730 (v1.1) June 14, 2010