Power; Moving The Scanner - Canon imageFORMULA CR-25 Startup Startup Manual

Power

• Connect only to a power outlet of the rated voltage and power supply
frequency (either 120 V, 60 Hz or 220-240 V, 50/60 Hz, depending on your
region).
• Do not connect to power outlets with other electrical devices. Also, when
using an extension cord, make sure that the extension cord is rated for the
current requirements of the scanner.
• Disassembling and/or reassembling the AC adapter is extremely dangerous
and should not be attempted under any circumstances.
• Do not place heavy objects on the AC adapter or power cord. Do not place
the adapter or cords in an area where they are likely to be stepped on.
• Do not use the power cord while it is bundled.
• Never pull directly on the power cord. To remove the plug from the outlet,
grasp the plug directly and remove it from the outlet.
• Keep the area around the power plug clear of articles so that the power plug
can be disconnected in an emergency.
• Use only the AC adapter provided with the product. Do not use the scanner's
AC adapter with any other product.
Model: MG1-3607
• If you have any questions about the AC adapter, contact your local
authorized Canon dealer or service representative for further information.

Moving the Scanner

• The scanner weighs approximately 4.4 lb (2 kg). When moving the
scanner, always hold it with both hands to avoid dropping it. If held with
one hand it can fall and be damaged or break.
• Make sure to disconnect the interface cable and power cord. If the scanner
is transported with these items plugged in, the plugs and connectors may be
damaged due to physical shock.
Before Using the Scanner
5