Mitsubishi Electric AG-150A-A Installation Manual page 14

7 Attach the controller to the A type installation plate with the
M4 roundhead screws (supplied).
8 Replace the AG-150A surface cover.
2-2. Wall-Embedded installation with an Electric box (PAC-YG83UTB; sold separately)
1 Ensure there is enough space to install the controller as shown below. Wall space (see diagram below) and 60 mm (2-
clearance behind the wall are required to mount an Electric box.
100 (3-
NOTES
* When installing two or more controllers side-by-side and horizontally ensure that there is at least 130 mm (5-
between the units.
* When installing two or more controllers vertically, ensure that there is at least 150 mm (5-
be hard to remove the cover.
* The amount of space required on the left of the controller is the amount necessary to connect/disconnect the USB drive. (If the
specified amount of space is not available, use a USB extension cable.)
* The amount of space required under the controller is the amount necessary for the mounting/dismounting of the controller
cover.
2 Punch out the appropriate knockout holes on the Electric box depending on how the cable is routed.
Punch out the knockout holes.
(Punch out the appropriate
knockout hole.)
3 Install the Electric box in the wall.
Refer to the Installation Manual that came with the Electric box (PAC-YG83UTB) for details.
30 (1- 3 / )
16
300 (11- 13 / )
16
15 / )
16
Inner wall
Unit: mm (in)
AG-150A
AG-150A
- 13 -
A type Installation plate
(supplied)
Electric box (PAC-YG83UTB; sold separately)
60 mm
(2- / in)
3
8
minimum
Building structure
1 / in) or more
8
15 / in) between units; otherwise, it will
16
M4 roundhead
screw (supplied)
3 / in) of
8