Mitsubishi Electric AG-150A-A Installation Manual page 12

4 By installing the centralized controller and a power supply unit
(PAC-SC51KUA; sold separately) inside the mounting
attachment on the wall.
Mounting attachment A type (PAC-YG85KTB; sold separately)
is required.
5 Attach the AG-150A to the control board.
2-1. Embedding the centralized controller in the wall.
1 Ensure there is enough space to install the controller as shown
in the figure at right.
NOTES
* When installing two or more controllers side-by-side and horizontally ensure that there is at least 130 mm (5-
between the units.
* When installing two or more controllers vertically, ensure that there is at least 150 mm (5-
be hard to remove the cover.
* The amount of space required on the left of the controller is the amount necessary to connect/disconnect the USB drive. (If the
specified amount of space is not available, use a USB extension cable.)
* The amount of space required under the controller is the amount necessary for the mounting/dismounting of the controller
cover.
2 Cut out an opening in the wall as shown in the shaded area
in the figure at right. (W × H: 278 mm (11 in) × 152 mm (6 in))
Follow the dimensions in the figure exacting. If the opening is
too large, it will be hard to properly install the unit.
Make mounting plate (A type and B type) screw holes on the
hole as shown in the right figure. (Use the supplied M4
screws to mount the plates.)
3 Insert the B type installation plate (supplied) through the hole
in the wall and hold it.
AG-150A
AG-150A
Control board
100 (3- / )
15
16
- 11 -
Wall
PAC-YG85KTB (sold
separately) is required
in wall mount
installation with both
the controller and a
power supply unit.
Power supply unit
(PAC-SC51KUA; sold
separately)
Wall
Power supply unit
(PAC-SC51KUA; sold
separately)
30 (1- 3 / )
16
300 (11- / )
13
16
1 / in) or more
8
15 / in) between units; otherwise, it will
16
278 (10- 15 / )
16
7
200 (7- / )
8
B type installation plate
(supplied)
Unit: mm (in)
AG-150A
Unit: mm (in)