Replace The Cutting Fluids; Maintenance And Replacement Period; Waste Disposition - Sharp RD-1230 Operation Manual

7.3 Replace the cutting fluids.

It requires only one person to do it. Please power off and press down the emergent stop
power button before carrying out the job.
The steps：
1. Power off.
2. Press down the emergent stop button.
3. Place a container under the oil drain outlet.
4. Release the drain plug using a spanner.
5. After draining, tape the plug with a sheet of band and tighten it back to the drain outlet.
6. Refill the cutting fluids through the oil filler inlet to the level under 5 mm under the oil filter.
7.4

Maintenance and replacement period.

No.
1. Oil filler points of the column
2. Oil filler points on top of the gearbox
3. Oil filler points in the right side of the gearbox.
4. Oil filler points in the left side of the gearbox.
5. Oil filler points of the spindle
6 Replace oil for the speed reduction of the arm
elevating motor.
7 Change oil inside of the gearbox.
8 Chang the cutting fluids.
9 The arm transmit ion ball screw
10. Replace the hydraulic oil
A suitable Oil Type comparison:
ISO DIS-3498
CB32
CC68
XM2

7.5 Waste disposition.

Please proceed waste disposition such as machine oil, iron filings, old machine or replaced
parts according to your country's relevant legal regulation.
Position
SHELL
TELLUS C32
OMALA 68 MOBILGEAR 620
ALVANIA R2
A. Instruction to the relevant parts.
1. Oil filler points
2. Oil drain outlet
B. The following is the tools to replace the cutting
fluids.
The cutting fluids 30L
Container and spanner
The cutting fluids
MOBIL
DTE OLL LIGHT
MOBILUX 2
7-6
Items.
CC68 once per day.
CC68 once per day.
CC68 once per day.
CC68 once per day.
XM2 once per day.
CC68 once per year.
CC68 once per year.
Once per month
XM2 Once per week
CB32 once per year.
ESSO
TERESSO 32
SPARTAN EP68
BEACON 2
Period
CHINA
R32
HD68
#2